Telnet Command: Wan Detect - Draytek VIGOR2925 SERIES User Manual

off
E x a m p
E x a m p
> wan wimax ?
Current status is wimax OFF
wan wimax on
>
>
T e l n e t C o m m
T e l n e t C o m m
This command allows you to Ping a specified IP to detect the WAN connection (static IP or
PPPoE mode).
wan detect [wan1][on/off/always_on]
wan detect [wan1]target [ip addr]
wan detect [wan1]ttl [1-255]
wan detect status
S y n t a x
S y n t a x
Parameter
on
off
always_on
target
ip addr
ttl
status
E x a m p
E x a m p
> wan detect status
WAN1: always on
WAN2: off
WAN3: off
WAN4: off
WAN5: off
> wan detect wan1 target 192.168.1.78
Set OK
> wan detect wan1 on
Set OK
Vigor2925 Series User's Guide
It means to disable WAN 3G/4G DHCP mode.
l e
l e
a n d : w a n d e t e c t
a n d : w a n d e t e c t
D e s c r i p t i o n
D e s c r i p t i o n
Description
It means to enable ping detection. The IP address of the target
shall be set.
It means to enable ARP detection (default).
disable link detect, always connected(only support static IP)
It means to set the ping target.
It means the IP address used for detection. Type an IP
address in this field.
It means to set the ping TTL value (work as trace route)
If you do not set any value for ttl here or just type 0 here, the
system will use default setting (255) as the ttl value.
It means to show the current status.
l e
l e
722