Ricoh AFICIO MP 8000 Operating Instructions Manual page 166

Problem
Printing does not start.
Printing does not start.
Printing does not start.
Printing does not start.
Data-in indicator does
not blink or light up.
The status indicator of
the printer is lit.
" Updating the
destination
list... Please
wait. Specified
destination(s) or
sender's name has
" ap-
been cleared.
pears.
[List / Test Print] is disa-
bled.
Printing does not start
when using the extended
wireless LAN in Ad-hoc
mode.
If the printing does not start, consult your service representative.
Cause
If the machine is operat-
ing in an extended wire-
less LAN, the receiver's
MAC address may be
preventing communica-
tion with the access point.
The extended wireless
LAN has not started.
The login user name,
login password, or driver
encryption key is invalid.
Advanced encryption has
been set using the Ex-
tended Security function.
If the data-in indicator is
unlit or not flashing even
after performing [Print],
the machine has not re-
ceived the data.
The cause is displayed on
the display of the control
panel.
The destination list is be-
ing updated from the net-
work using
SmartDeviceMonitor for
Admin.
A mechanical error might
have occurred.
The correct Communica-
tion Mode is not set.
When You Cannot Print
Solution
Check access point settings when in the
infrastructure mode. Depending on the
access point, client access may be limit-
ed by MAC address. Also, check there
are no problems in transmission be-
tween access point and wired clients,
and between access point and wireless
clients.
Confirm the orange LED is lit, and the
green LED is lit or blinks during trans-
mission.
Check the login user name, login pass-
word, or driver encryption key.
Check the settings of the Extended Se-
curity function with the administrator.
• When the machine is connected to a
computer via a cable, check the
computer print port settings are cor-
rect. See "Confirming the Connec-
tion Method", Printer Reference.
• When it is networked with a com-
puter, Contact the administrator.
Check the error message on the display
panel and take required action. See p.54
"Messages Displayed When Using the
Printer Function".
Wait until the message disappears. Do
not switch off the power while this
message is displayed. Depending on
the number of destinations to be updat-
ed, there may be some delay before you
can resume operation. Operations are
not possible while this message is dis-
played.
Contact your service representative.
See "List/Test Print", General Settings
Guide.
Turn the main power off and back on.
See "Turning On the Power", About
This Machine.
Or, change the settings for [System Set-
tings], [Interface Settings], and [Network].
See "Network Settings", General Set-
tings Guide.
4
65