CYBEX CLOUD Q Owner's Manual page 39

INSTALLING INFANT CARRIER ONLY WITH A LAP/SHOULDER BELT
7. Make sure the vehicle is on level ground. Check the recline
angle. Adjust the seat angle until the red line on the Infant
Carrier is level with the ground. A tightly rolled towel or
pool noodle may be placed under the Infant Carrier near
the vehicle seat back to adjust the angle. See page 43.
The Cloud Q is allowed to touch the vehicle seat(s) in front of it, as
long the recline angle of the Cloud Q is not affected.
8. Grab the Infant Carrier at the Belt Guides and pull
from side to side and front to back to make sure it
is installed correctly. The Infant Carrier should not
move more than 1 inch (2.5 cm) in any direction.
If the Infant Carrier moves too much, tighten the vehicle belts more
and recheck. You may try a different vehicle seat or installation
method, or both.
9. If the Infant Carrier is next to a vehicle door or panel,
extend the adjacent L.S.P. device. See page 42.
ALWAYS have the handle locked in the DRIVE position
while using this child restraint in a vehicle.
FRONT OF VEHICLE

FRONT OF VEHICLE
7
LINE MUST BE LEVEL WITH GROUND
WHEN INSTALLED WITHOUT BASE
FRONT OF VEHICLE
LINE MUST BE LEVEL WITH GROUND
WHEN INSTALLED WITHOUT BASE
9
FRONT OF VEHICLE
(Image shown from opposite side
compared to illustrations to the left)
38