CYBEX CLOUD Q Owner's Manual page 40

INSTALLING INFANT CARRIER ONLY WITH A LAP/SHOULDER BELT (ALTERNATE)
Use this alternate installation method only when the preferred
method found on page 37 does not work with your vehicle Lap
and Shoulder belts.
1. Position Infant Carrier on a rear vehicle seat, with the
foot end firmly against the back of the vehicle seat.
2. Route only the vehicle lap belt under BOTH THE HANDLE
AND CARRIER Belt Guides. BUCKLE THE BELT.
3. LOCK your vehicle lap shoulder belt. Refer to
your vehicle Owner's Manual
vehicle lap and shoulder belt locks.
In many vehicles, you can switch the shoulder belt retractor into locking
mode by pulling the shoulder belt out all the way. In some vehicles the
buckle locks. Check the vehicle Owner's Manual
system locks.
To check if the vehicle belt is locked, after you install the infant carrier, pull
up firmly on the lap belt between the Belt Guides. The belt should remain
tight if the vehicle system is locked.
4. Push Infant Carrier firmly into vehicle seat, pressing down
near the crotch strap between the child's legs
removing slack from lap belt. Repeat for shoulder belt.
NEVER install this child restraint using a non-locking
vehicle lap shoulder belt. A locking clip must be used
with a vehicle belt that DOES NOT LOCK. Call the
CYBEX Customer Care Department at 1.877.242.5676 to
obtain a locking clip.
5. Make sure that vehicle belt buckle and hardware
DO NOT INTERFERE with the Infant Carrier.
39
for how your
to see how your
a
, while
b
1
3
5
2
CLICK!
4
b
a