CYBEX CLOUD Q Owner's Manual page 42

INSTALLING THE INFANT CARRIER WITH A LAP BELT ONLY
1. Position Infant Carrier on a rear vehicle seat, with the
foot end firmly against the back of the vehicle seat.
2. Route vehicle lap belt under BOTH THE HANDLE
AND CARRIER Belt Guides. BUCKLE THE BELT.
3. Push Infant Carrier firmly into vehicle seat, pressing
down near the crotch strap between the child's
legs, while removing slack from the lap belt.
4. If necessary, tuck the loose end of the lap belt out of the way.
5. Check the recline angle. Adjust the seat angle until the red Level
Line on the Infant Carrier is level with the ground. A tightly rolled
towel or pool noodle may be placed under the Infant Carrier
near the vehicle seat back to adjust the angle. See page 43.
The Cloud Q is allowed to touch the vehicle seat(s) in front of it, as
long the recline angle of the Cloud Q is not affected.
6. Grab the Infant Carrier at the Belt Guides and pull
from side to side and front to back to make sure it
is installed correctly. The Infant Carrier should not
move more than 1 inch (2.5 cm) in any direction.
7. If the Infant Carrier is next to a vehicle door or panel,
extend the adjacent L.S.P. device. See page 42.
If the Infant Carrier moves too much, tighten the vehicle belts more
and recheck. You may try a different vehicle seat or installation
method, or both .
ALWAYS have the handle locked in the lowered DRIVE
position while using this child restraint in a vehicle.
41
1
2
3
FRONT OF VEHICLE
CLICK!
4
LINE MUST BE LEVEL WITH GROUND
WHEN INSTALLED WITHOUT BASE
FRONT OF VEHICLE
5
LINE MUST BE LEVEL WITH GROUND
WHEN INSTALLED WITHOUT BASE