Norac UC5 Installation Manual page 8

2.2.3 Control Module on Sprayer (Non-ISOBUS Ready Tractor)
Cable C42 is required for this type of installation. Please order the following cable from
NORAC:
Item Part Number
C42 43260-29
1. Securely mount the control module (E01) on the sprayer near the CANbus connection.
2. Tee the CANbus interface cable (C42) between Trimble cable 77368 and the IBRC
connector.
3. Connect the 6 pin Deutsch plug on cable C42 to the end of the control module with only
one Deutsch connector.
4. Connect cable C01 to the other CANbus connector and route the cable towards the rear
of the sprayer.
Note: Not all cables listed in the List of Parts (Section 1.1) are used for this type of installation.
Figure 4: Pull Type with Control Module on Sprayer (Non-ISOBUS Ready Tractor) Installation
6
Name
CABLE UC5 INTERFACE DT 4 PIN 12 IN STUB
Quantity
1