Installation; Self-Propelled - Norac UC5 Installation Manual

Spray height control system display kit for trimble fmx

Hide thumbs Also See for UC5:

Table of Contents

2 Installation

The following instructions are for installation on a self-propelled sprayer (Section 2.1) or pull

type sprayer (Section 2.2).

2.1

1. Securely mount the control module (E01) inside the sprayer cab.

2. Tee the CANbus interface cable (C40) between the Trimble cable 75834 and the ISOBUS

trunk cable that runs to the back of the sprayer.

3. Connect the 6 pin Deutsch plug on cable C40 to the end of the control module with only

one Deutsch connector.

4. Connect cable C01 to the other CANbus connector and route the cable towards the rear

of the sprayer.

Note: Not all cables listed in the List of Parts (Section 1.1) are used for this type of installation.

Figure 1: Self Propelled Sprayer Installation

Table of Contents