Pull Type - Norac UC5 Installation Manual

Spray height control system display kit for trimble fmx

Hide thumbs Also See for UC5:

Table of Contents

2.2

Pull Type

2.2.1

Control Module on Tractor (Non-ISOBUS Ready Tractor)

1. Securely mount the control module (E01) inside the tractor cab.

2. Tee the CANbus interface cable (C40) between Trimble cable 75834 and Trimble cable

77368.

3. Connect the 6 pin Deutsch plug on cable C40 to the end of the control module with only

one Deutsch connector.

4. Connect cable C41 to the CANbus connector and route the cable to the hitch of the

tractor. Connect the two-way coupler (E12) to the end of cable C41.

5. Connect cable C01 to the coupler (E12) and route towards the rear of the sprayer. The

two-way coupler (E12) will provide the hitch disconnect.

Figure 2: Pull Type with Control Module on Non-ISOBUS Ready Tractor Installation

Table of Contents