Reference To Further Documentation; Marking; Intended Use - Pepperl+Fuchs KFD2-HLC-Ex1.D Series Manual

HART Loop Converter KFD2-HLC-Ex1.D(.**)
Safety
1.4

Reference to further documentation

Laws, standards, or directives applicable to the intended use must be observed. In relation
to hazardous areas, Directive 1999/92/EC must be observed.
The corresponding data sheets, declarations of conformity, EC-type-examination
certificates, certificates and Control Drawings if applicable (see data sheet) are an integral
part of this document. You can find this information under www.pepperl-fuchs.com.
Due to constant revisions, documentation is subject to permanent change. Please refer only
to the most up-to-date version, which can be found under www.pepperl-fuchs.com.
1.5

Marking

HART Loop Converter
Pepperl+Fuchs GmbH
Lilienthalstrasse 200, 68307 Mannheim, Germany
KFD2-HLC-Ex1.D
KFD2-HLC-Ex1.D.2W
KFD2-HLC-Ex1.D.4S
BASEEFA 07 ATEX 0174 , for additional certifications, see www.pepperl-fuchs.com
E II (1)GD [Ex ia] IIC, [Ex iaD]
Pepperl+Fuchs Statement of Conformity
E II 3G Ex nA II T4 X
1.6

Intended Use

The devices are only approved for appropriate and intended use. Ignoring these instructions
will void any warranty and absolve the manufacturer from any liability.
The device must only be operated in the ambient temperature range and at the relative
humidity (non-condensing) specified.
The devices are used in C&I technology for the galvanic isolation of C&I signals such as
20 mA and 10 V standard signals or alternatively for adapting or standardizing signals.
Devices that incorporate intrinsically safe circuit are used for operating intrinsically safe field
devices in hazardous areas.
EN
EN - 5