Pepperl+Fuchs KFD2-HLC-Ex1.D Series Manual page 46

HART Loop Converter KFD2-HLC-Ex1.D(.**)
Installation
Fault Message
EN
Calling up a Fault Message
1.
2.
3.
Activating the Restart Inhibit
The restart inhibit is used to prevent momentary trip value violations from not being noticed
by operating personnel.
1.
2.
3.
44 - EN
Use the  or buttons to select the Fault message menu.
If the fault message menu is activated, press the OK button once.
The Restart inhibit submenu is displayed.
If the fault message menu is not activated, press the OK button twice.
The Restart inhibit submenu is displayed. The Fault message menu is activated
and is marked as On.
Fault (On)
Use the  or buttons to select On.
Confirm your selection with OK.
The relay status is retained after switching the relay.
If you would like to reset the relay status, press the ESC or
button or restart the device.
The relay is reset. Exception: there is a fault message.
OK →
Restart Inhibit
← ESC
OK →
On
← ESC
▼ ▲
OFF