Pepperl+Fuchs KFD2-HLC-Ex1.D Series Manual page 29

HART Loop Converter KFD2-HLC-Ex1.D(.**)
Installation
Entering a Numerical Value
1. Select the parameter for which you want to enter the numerical value.
2. Press the OK button.
The current value from the mantissa and exponent flashes.
3. Press the OK button.
With positive numbers, the first digit of the mantissa flashes.
With negative numbers, the minus sign flashes.
4. To change the value in steps from 0 to 9, press the  or  button.
To enter a minus sign, press the  until the first digit is less than 0.
5. Confirm your selection with OK.
The next digit of the mantissa flashes.
6. Repeat steps 4 and 5, until all digits have been entered.
7. Confirm your entry with OK.
The position of the decimal point flashes.
8. Press the  or  button to specify the position of the decimal point.
9. Confirm your entry with OK.
The exponent flashes.
10. To specify the value of the exponent, press the  or  button. You can select the
exponents from E-33 to E33 in increments of three.
11. Confirm your entry with OK.
The new value is stored.
EN
EN - 27