Device Description / Spare Parts; Assembly; Commissioning - ATIKA HA 500/51 Original Instructions Manual

• This device is not intended to be used by persons (including
children) with restricted physical, sensory or mental abilities
or a lack of experience and/or know-how unless they are
supervised by a person responsible for their safety or they
have been instructed by such a person on the use of the
device.
Supervise children to make sure they do not play with the
device.
Safe working
• Do not modify the device or parts of the device respectively.
• The operator is responsible to third persons within the area
of operations.
• Adhere to national regulations that might specify an age limit
for the user of the unit.
• Stop the hedge trimmer when moving to another work place.
• Always hold the hedge trimmer with both hands - one hand
on the front handle and the other on the rear handle.
• Make sure that you can step back safely without hindrances.
• Before trimming, remove all foreign objects (e.g. stones,
branches, wires, etc.). While working watch out for further
foreign objects.
• Be sure that the cutting tool already moves before you start
cutting.
• Caution! The cutting tool stops delayed after the machine is
switched off. Do not try to slow down the cutting tool by the
hand.
• After a longer period of use, accessible metallic parts and
accessories may be hot.
• Turn off the machine, remove the battery and wait until the
cutting tool is stationary when
− the cutting tool comes into contact with soil, stones, nails
or other foreign objects (
tool/machine is damaged)
− removal of faults (including blocking of knives)Leaving
the machine (also during temporary interruption)
• Maintain your hedge trimmer with care:
− Before each starting of the machine the safety devices
must be checked carefully for their proper and intended
function. Do not modify things on the machine that could
impair its safety.
− Damaged or illegible safety warning labels should be
replaced immediately.
Repairs to other parts of the machine must be carried out
by the manufacturer or one of his customer service
points.
Use only original spare parts, accessories and special
accessory parts. Accidents can arise for the user through
the use of other spare parts. The manufacturer is not
liable for any damage or injury resulting from such action.
check whether the cutting
Description / Spare parts
Pos. Denomination
1/
Knife
2
Knife protection HA 500/51
Knife protection HA 620/55
Knife protection HA 710/61
3
Hand guard (HA 500/51)
Hand guard (HA 620/55, HA 710/61)
4
Safety label
5
Front handhold with switch button
6
Ventilation slots
7
Rear handhold with ON- OFF switch
8
Cable with power plug
9
Cover strip
10
Impact protection
11
Switch for the angular motion of the
rear handhold
Attach the hand guard (3) with screws to the device
prior to startup.

Commissioning

Mains connection
Compare the voltage given on the machine model plate e.g.
230 V with the mains voltage and connect the hedge trimmer to
the relevant and properly earthed plug.
Alternating current motor:
Use a shockproof plug, mains voltage 230 V with
residual current circuit breaker 30 mA and 10 A fuses.
Use connection cable or extension cable respectively with a
cross section of at least 1.5 mm².
Mounting of the extension cable
In order to prevent an unintended loosening of the
connection assembly put the extension cable as noose
through the opening on the rear handhold (7) and put it over
the cable mounting.
Switch on
Order-No.
364196
164197
364198
364193
364194
364190
364199

Assembly

17