Going Into Level 2 Mode From Level 1 Mode - Ricoh FAX3700l Service Manual

August 2nd, 1995
Cross Reference
Fusing lamp control during Power Saver Mode: User Switch 05, bit 6
(On at printing temperature, On at standby temperature, or Off)
Note
The "optional equipment" in condition #3 is either a Printer Interface or a RS232C
Interface.

2. Going into Level 2 Mode from Level 1 Mode *

The flow chart on the next page shows in more detail how the machine goes
from Power Saver Mode Level 1 to Level 2.
The machine will not go into Level 2 power saver mode if one of the following
conditions exists.
•
Either a tx/rx/polling file is stored in the memory.
•
SAF memory not empty
•
Mechanical error(s)
•
NCU off-hook
•
Optional equipment installed (a paper feed unit, printer interface, and/or
RS232C interface)
If there is a tx file in the memory
The machine stays in Power Saver Mode Level 1 until it is time to send the
message. The machine then enters Level 0 while the message is sent. See
point 1 on the flow chart.
When the Power Saver timer expires
When the power saver timer expires after the machine entered Level 1 for the
first time (or, if a tx file was present, after the message was transmitted), the
machine will enter Level 2 if both of the following are met:
•
User Switch 05, bit 6 specifies Fusing Lamp Off
•
No condition #1 restrictions exist.
See point 2 on the flow chart.
DETAILED SECTION DESCRIPTIONS
2-49
SYSTEM FEATURES