Buttons
Use the sensor buttons (SELECT)(TEACH), (+)(DISP), and (-)(MODE) to program the sensor.
(SELECT)(TEACH)
•
Press and hold for longer than 2 seconds to start
the currently selected TEACH mode (the default is
two-point TEACH)
•
Press to select menu items in Setup mode
(-)(MODE)
•
Press to change the distance setting for the 0 V (4
mA ) point; press and hold to decrease numeric
values
•
Press and hold for longer than 2 seconds to enter
Setup mode
•
Press to navigate the sensor menu in Setup mode
Laser Description and Safety Information
CAUTION: Use of controls or adjustments or performance of procedures other than those specified
herein may result in hazardous radiation exposure. Do not attempt to disassemble this sensor for
repair. A defective unit must be returned to the manufacturer.
Class 1 Lasers
Class 1 lasers are lasers that are safe under reasonably foreseeable conditions of operation, including the use of optical
instruments for intrabeam viewing.
Laser wavelength: 655 nm
Installation
Install the Safety Label
The safety label must be installed on Q4X sensors that are used in the
United States.
NOTE: Position the label on the cable in a location that
has minimal chemical exposure.
1. Remove the protective cover from the adhesive on the label.
2. Wrap the label around the Q4X cable, as shown.
3. Press the two halves of the label together.
2
(+)(DISP)
Output: < 0.20 mW
www.bannerengineering.com - Tel: +1-763-544-3164
Q4X Stainless Steel Analog Laser Sensor
•
Press to change the distance setting for the 10 V
(20 mA) point; press and hold to increase numeric
values
•
Press and hold for longer than 2 seconds to toggle
the display value between the distance and the
analog output
•
Press to navigate the sensor menu in Setup mode
NOTE: When navigating the menu, the
menu items loop.
Pulse Duration: 7 µs to 2 ms
COMPLIES WITH 21 CFR 1040.10 AND 1040.11
EXCEPT FOR DEVIATIONS PURSUANT TO
LASER NOTICE No. 50, DATED JUNE 24, 2007.
BANNER ENGINEERING CORP.
9714 10TH AVENUE NORTH
MINNEAPOLIS, MN 55441
Figure 4. Safety Label Installation
CLASS 1
LASER PRODUCT
COMPLIES WITH IEC 60825-1:2007
P/N 185623 Rev. D