Laser Description And Safety Information - Banner Q4X Series Instruction Manual

(SELECT)(TEACH)
• Press and hold for longer than 2 seconds to start the
currently selected TEACH mode (the default is two-point
TEACH)
• Press to select menu items in Setup mode
(-)(MODE)
• Press to change the distance setting for the 0 V (4 mA )
point; press and hold to decrease numeric values
• Press and hold for longer than 2 seconds to enter Setup
mode
• Press to navigate the sensor menu in Setup mode

1.4 Laser Description and Safety Information

CAUTION: Use of controls or adjustments or performance of procedures other than those specified herein may result in
hazardous radiation exposure. Do not attempt to disassemble this sensor for repair. A defective unit must be returned to the
manufacturer.
Class 1 Lasers
Class 1 lasers are lasers that are safe under reasonably foreseeable conditions of operation, including the use of optical instruments
for intrabeam viewing.
Laser wavelength: 655 nm
(+)(DISP)
•
•
•
Output: < 0.20 mW
www.bannerengineering.com - Tel: 763.544.3164
Q4X Stainless Steel Analog Laser Sensor
Press to change the distance setting for the 10 V (20 mA)
point; press and hold to increase numeric values
Press and hold for longer than 2 seconds to toggle the
display value between the distance and the analog output
Press to navigate the sensor menu in Setup mode
Note: When navigating the menu, the menu items
loop.
Pulse Duration: 7 µs to 2 ms
5