Banner Q4X Quick Start Manual page 5

Q4X Stainless Steel Analog Laser Sensor
Top Menu
Teach Process Selection
Base Measurement Rate
Averaging
Slope
Select Zero Reference Location
Shift Zero Reference after Teach
Loss of Signal
Input Wire Function
Trigger Mode
Display Read
Exit Setup
Reset to Factory Defaults
P/N 185623 Rev. D
Sub Menus
two-point teach
one-point teach
set Base Measurement Rate to 0.3 ms
set Base Measurement Rate to 0.5 ms
set Base Measurement Rate to 1.0 ms
set Base Measurement Rate to 2.5 ms
set Base Measurement Rate to 5.0 ms
average 1 measurement for analog output
average 2 measurements for analog output
average 4 measurements for analog output
average 8 measurements for analog output
average 16 measurements for analog output
average 32 measurements for analog output
average 64 measurements for analog output
average 128 measurements for analog output
average 256 measurements for analog output
average 512 measurements for analog output
positive slope
negative slope
near: set zero displayed value to end of 18 mm barrel
far: set zero displayed value to maximum detection range
on: move the zero point after each teach
off: zero point is either at end of barrel or
maximum detection range
current models voltage models
(3.5 mA) (0 V)
(20.5 mA) (10.5 V)
hold hold
off: remote teach input is not active
set: Remote Teach input
laser off when pulled low
laser on when pulled low
master
slave
trigger
average measurement
range (max. dist - min. dist)
max. distance
min. distance
track max. distance
track min. distance
sample measurement
Trigger Mode appears when Input Wire Function is set to "trigger"
display on
display on, inverted
display off (enters sleep mode after 60 seconds)
display off, inverted (enters sleep mode after 60 seconds)
end: select to exit setup
no: do not reset to factory defaults
yes: reset to factory defaults
Figure 10. Sensor Menu Map
www.bannerengineering.com - Tel: +1-763-544-3164
( default setting)
5