Modes Of Operation; Standard Mode; Reversing Mode; Condominium Mode - Centurion D10 User Manual

4.1.2. Modes of Operation

To operate the gate to open fully, the D5-Evo DOMESTIC, D10 and D10 Turbo have
a number of operating modes to choose from depending on the application. Only one
mode can be selected at any given time, unless indicated otherwise.

4.1.2.1. Standard Mode

Standard Mode is the most commonly used mode for domestic applications as it allows
full control of the gate. Press the button of the remote control or the gate / door release
pushbutton on the intercom for approximately one second to get the gate in motion.
If you press the button again, while the gate is moving, the gate will stop. Press the
button for a third time and the gate will go into reverse.
Autoclose and PIRAC (Beam Autoclose) can be used with Standard
Mode. An infrared safety beam needs to be installed across the gate
entrance and connected to the Closing Safety Beam input on the D5-Evo
DOMESTIC or D10/D10 Turbo to use this function, in order to prevent
the gate from closing on people, pets or vehicles.

4.1.2.2. Reversing Mode

Reversing Mode offers slightly more security than Standard Mode as it allows you to close
your gate quickly by pressing, for instance, your remote control just as you drive through
the gate to prevent children or pets running out - or anybody getting in behind you.
When pressing the button of the remote control or the gate / door release pushbutton on
the intercom, your gate will be set in motion. If you press the button again, the gate will
move in the opposite direction. So, if the gate is opening and you press the button, the
gate will stop and immediately start to close (and vice versa)
Autoclose and PIRAC (Beam Autoclose) can be used with Reversing
Mode. An infrared safety beam needs to be installed across the gate
entrance and connected to the Closing Safety Beam input on the D5-Evo
DOMESTIC or D10/D10 Turbo to use this function, in order to prevent
the gate from closing on people, pets or vehicles.

4.1.2.3. Condominium Mode

This mode is ideal for increased safety and security in multi-user applications such as
townhouses, estates, factories or office parks. If you select Condominium Mode, your
gate will open when pressing the button of the remote control or the gate / door release
pushbutton on the intercom – but pressing the button again while gate is opening will
be ignored. It will not cause the gate to stop or to reverse. Only the internal Autoclose
described on page 11 of this User Guide, which is automatically enabled, will close the
gate. If the button of the remote control or intercom gate release is pressed while the
gate is closing, the gate will immediately reopen. The gate cannot be stopped in a
midway position and will therefore always close. If the button is pressed while the gate is
in the open position, the Autoclose timer is reset. Finally, the Autoclose Override feature
described on page 11.
www.CentSys.com page 17