Connecting Power; Basic Functions - Vitek VT-3468 BK Instruction Manual

ENGLISH
b) There are foreign objects inside the unit.
c) If the unit has been exposed to rain or water.
d) If the unit does not operate normally by fol-
lowing the operating instructions.
e) If the unit has been dropped or its cabinet has
been damaged.
f) When the unit exhibits a distinct change in
performance-this indicates a need for serv-
ice.
Cleaning
Unplug this unit from the wall outlet before clean-
ing. Use a damp cloth for cleaning. Do not use
liquid cleaners or aerosol cleaners.
Cleaning discs
Do not use cracked or deformed discs, it can
damage a unit.
Hold the disc by the edges. Do not touch the sur-
face. Dust, scratches or fingerprints on the sur-
face may lead to a failure of the unit.
Protect the disc from direct sunlight; keep them
away from heat sources, high temperature and
moisture.
After usage, put the discs in the case for stor-
age.
Wipe periodically the surface of the discs with a
soft cloth from the center to the edges.
DESCRIPTION
1. FM –antenna
2. VOLUME control
3. FUNCTION (RADIO /CD/MP3/USB /OFF)
SWITCH
4. TUNING knob
5. Discs compartment
6. BAND (AM /FM/ FM ST) switch
7. OPEN/CLOSE ledge
8. LCD-display
9. STOP button
10. SKIP + button
11. SKIP - button
12. PLAY/PAUSE
13. FM ST indicator
14. ALBUM button
15. PROG button
16. MODE button
17. USB flash drive jack
18. TIME SET button
19. HOUR button
20. MINUTE button
21. Power in jack
22. Battery compartment lid
Downloaded From Disc-Player.com Vitek Manuals
3468IM.indd 4 3468IM.indd 4
button

CONNECTING POWER

Line supply
Before connecting the unit, make sure that your
home electricity supply corresponds to the volt-
age specified on the unit.
1. To connect the unit to the mains, insert one
end of the power cord into the (21) jack and
the other one – into the socket. Set the FUNC-
TION switch to CD/MP3/USB or RADIO.
2. To switch off the unit set the FUNCTION
switch to the OFF position.
Note: Static electricity can lead to interfer-
ences in the operation of the unit. In this case
disconnect the unit, and then connect it again.
If the problem does not disappear, apply to the
service center.
Battery supply
1. Disconnect the unit.
2. Open the battery compartment lid (22) on
the backside of the unit, by pressing the two
clamps in the direction of the arrows.
3. Insert 8 "С" (UM 2) 1,5V batteries (not sup-
plied) into the battery compartment.
4. Close the battery compartment lid.
Attention! Battery leakage can lead to injuries
and damages of the unit. To avoid damages of
batteries follow the instructions below:
- place the batteries properly;
- take the batteries out if you are not going to
use the unit for a long time;
- do not recharge batteries, do not dismantle
them, and do not subject to high tempera-
tures;
- replace the batteries in time.
Note: When the unit is in the standby mode,
it still consumes energy, to switch off the unit
completely, take the power cord out of the
socket and remove the batteries from the bat-
tery compartment.

BASIC FUNCTIONS

Volume control
To select the desired volume level, use the vol-
ume control.
Radio stations reception
1. Set the FUNCTION switch to the RADIO po-
sition.
2. Select the desired band: FM, FM ST or AM,
4
27.07.2010 15:43:21 27.07.2010 15:43:21