Race Mode - Yamaha WR250F 2016 Owner's Service Manual

Returning to BASIC MODE from RACE
MODE
TIP
It is possible to return to BASIC MODE with tim-
er measurement at a stop.
1. Check that the timer is not in operation. If the
timer is in operation, stop the timer by push-
ing the "SLCT1" button and "SLCT2" button
at the same time.
2. Push the "SLCT1" button and "SLCT2" but-
ton for 2 seconds or more at the same time
to change over to BASIC MODE.

RACE MODE

EAS2GB7046
Putting measurement on standby
TIP
Starting measurement consists of the following
two starts, either of which can be selected.
• Manual start
Starting measurement by the rider himself op-
erating the button. (A long push on the
"SLCT2" button will put measurement on
standby.)
• Auto start
Starting timer measurement automatically on
detection of the movement of the machine. (A
long push on the "SLCT1" button will put mea-
surement on standby.)
MULTI-FUNCTION DISPLAY
Manual start
TIP
Initial setting at changeover to RACE MODE
will remain for manual start.
1. Check that changeover to RACE MODE has
been made. (Refer to "Changeover from BA-
SIC MODE to RACE MODE".)
TIP
When the machine is made ready for a run by
manual start,
2. Start timer measurement by pushing the
"RST" button.
3. When stopping timer measurement, pushing
the "SLCT1" button and "SLCT2" button at
the same time.
TIP
If the machine is run while timer measurement
is not made, no change will occur to the digit in
tripmeter A (TRIP A).
4. To resume the measurement, again push
the "SLCT1" button and "SLCT2" button at
the same time.
Auto start
1. Check that changeover has been made to
RACE MODE. (Refer to "Changeover from
BASIC MODE to RACE MODE".)
2. Make the machine ready for a run by push-
ing the "SLCT1" button for 2 seconds or
more.
TIP
When the measurement is made ready for a
run by auto start,
Timer display will turn on scrolling from left to
right.
1-24
and will start flashing.
and will start flashing.