Yamaha WR250F 2016 Owner's Service Manual page 295

2. Install:
• Washer
• Generator rotor nut "1"
Generator rotor nut
65 Nm (6.5 m·kgf, 47 ft·lbf)
TIP
Tighten the generator rotor nut to 65 Nm (6.5
m·kgf, 47 ft·lbf), loosen and retighten the gener-
ator rotor nut to 65 Nm (6.5 m·kgf, 47 ft·lbf).
1
3. Install:
• Starter idle gear shaft "1"
• Bearing "2"
• Starter idle gear 2 "3"
TIP
Apply the engine oil on the starter idle gear
shaft, bearing and idle gear inner circumfer-
ence.
1
1
2 2
3
4. Install:
• Dowel pin
• Crankcase cover gasket
• Left crankcase cover "1"
• Lead holder "2"
• Crankcase cover bolt
Crankcase cover bolt
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
• Neutral switch lead "3"
GENERATOR AND STARTER CLUTCH
New
6-66
TIP
• Pass the AC magneto lead "4" under the left
crankcase cover "a" as shown.
• Tighten the bolts in stage, using a crisscross
pattern.
1
3
2
5. Install:
• Washer "1"
• Damper assembly "2"
• Washer "3"
TIP
Apply the engine oil to the shaft and washers.
1
2 2
3
6. Install:
• Cover (damper assembly) "1"
• Bracket "2"
• Bolt "3"
• Breather hose 2 "4"
Bolt
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
4
a
1