b. Check the starter motor operation.
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
CHECKING THE STATOR COIL
EAS28150
1. Disconnect:
• Stator coil coupler
(from the wire harness)
2. Check:
• Stator coil resistance
Out of specification Replace the stator
coil.
Stator coil resistance
0.528–0.792 (W–W)
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Connect the pocket tester ( 1) to the sta-
tor coil coupler as shown.
Pocket tester
90890-03112
Analog pocket tester
YU-03112-C
• Positive tester probe
White "1"
• Negative tester probe
White "2"
• Positive tester probe
White "1"
• Negative tester probe
White "3"
• Positive tester probe
White "2"
• Negative tester probe
White "3"
ELECTRICAL COMPONENTS
b. Measure the stator coil resistance.
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
CHECKING THE RECTIFIER/REGULATOR
EAS2GB7394
1. Check:
• Charging voltage
Out of specification Replace the rectifier/
regulator.
No load regulated voltage
14.1–14.9 V
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Set the digital tachometer to the ignition coil.
Digital tachometer
90890-06760
Digital tachometer
YU-39951-B
b. Connect the pocket tester (DC 20 V) to the
rectifier/regulator coupler as shown.
Pocket tester
90890-03112
Analog pocket tester
YU-03112-C
• Positive tester probe
Red "1"
• Negative tester probe
Black "2"
c. Start the engine and let it run at approxi-
mately 5000 r/min.
d. Measure the charging voltage.
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
9-76
1
2
3
1
2