Remove/Replace The Accessory Board (A000451) - Fargo HDP8500 Service Manual

Remove/Replace the Accessory Board (A000451)

Step Procedure
1
Caution: Turn OFF the Printer and unplug the power cord from the Printer.
2 Disconnect the Ribbon cables from the Main Board ( J1 & J2) and from the Accessory Board
(J2 & J4).
3 Use a long Torx screwdriver to remove the four (4) screws that attach the Board to the base
plate. Work from the top of the Flipper Table.
4 Replace it with the new Accessory Board (A000451)
5 Reconnect the cables.
6 Reverse the instructions to re-assemble.
HDP8500 Service Manual, PLT-01583, 1.1
© 2013 HID Global Corporation/ASSA ABLOY AB. All rights reserved.
Tools needed: T10 Driver
Estimated Time: 30 minutes
Preparation: Remove Rear/Top Covers.
Remove the Front Panel
Remove the Output Cover
Important: This procedure can only be performed
by authorized service personnel.
97