Fargo HDP8500 Service Manual page 62

Step Procedure
3 Remove the one (1) screw that holds the Mount to the Frame. (Note: The Mount is flush
with the Frame when properly fitted.)
Pull out the Motor. Press the locking tab located on the right side of the Motor IN to release
the Motor.
4 Disconnect the Headlift Sensor from the Harness.
Leave the Sensor (D910216) in the Mount (if not replacing it).
5 If you need to replace the Sensor use a small flathead screwdriver to release the Sensor.
Move the flag from out of the Sensor area to clear the Sensor.
a. Slide the Sensor out from the tabs.
b. Replace it with the new Sensor and click it back into place.
(continued next page)
HDP8500 Service Manual, PLT-01583, 1.1
© 2013 HID Global Corporation/ASSA ABLOY AB. All rights reserved.
62