SECTION 7
18. Secure the cable with tie wraps as shown
by arrows. Do not tie any wires with the
nearby twisted pair.
19. Plug 5-pin jumper into J11
header. This can be done
by either inserting the jumper
from above or by removing
the driver pc board. Remov
ing the driver pc board will
allow easier access. Ensure
board is reinstalled properly by
aligning three long header pins
and fully snapping board
into place on mounting pillars.
Installing this plug will change
the Trigger Lock switch on the
front panel for mechanized log
ic. Refer to the mechanized
section of the machine instruc
tion manual.
three long header pins
MEChANIZED CONVERSION
5-pin jumper
J11 header
J11 header
5-pin jumper
mounting pillars
158
driver pc board