ESAB Powercut 1600 Service Manual page 156

SECTION 7
10. Connect the pc board to the main power control board as shown below.
Secure the pc board to the frame with the screw provided.
11. Connect the fast-on connectors of the
"2-wire cable" to the 14 pin cable.
12. Route the "2-wire cable" under the pc
board and tie wrap to the frame using
the provided holes in the areas shown.
13. Re-install the plugs and tie wraps on the
previously unplugged wires.
fast-on connectors
MEChANIZED CONVERSION
Install tie wraps as shown by arrows
156