ESAB Powercut 1600 Service Manual page 155

SECTION 7
7. Tighten the strain relief nut from the inside first ..;.....
8. Align the 10-pin connector with the pc board
header to identify which end of the connector is
pin 1 and therefore ensure proper connections
of the 9 cables wires.
9. Install each wire and tighten. Cable wires are
numbered 2 through 10 and must be connected in
numerical sequence starting with number 2. The
pc board has been stamped with numbers 1 and
10 to show the direction of sequence for the wires.
MEChANIZED CONVERSION
..... and then tighten the outside strain relief nut.
each wire is numbered
155
pin 1 is blank
1
2
3
4
5
6
7