Table of Contents
Advertisement
Troubleshooting
•
Update the network firmware in the scanner or print server. For more information, visit the Lexmark Web site at
http://support.lexmark.com.
Non‑Lexmark [supply type], see User's Guide [33.xy]
Note: The supply type can be a toner cartridge or the imaging unit.
The printer has detected a non‑Lexmark supply or part installed in the printer.
Your Lexmark printer is designed to function best with genuine Lexmark supplies and parts. Use of third-party supplies
or parts may affect the performance, reliability, or life of the printer and its imaging components.
All life indicators are designed to function with Lexmark supplies and parts, and may deliver unpredictable results if
third-party supplies or parts are used. Imaging component usage beyond the intended life may damage your Lexmark
printer or associated components.
Warning—Potential Damage: Use of third-party supplies or parts can affect warranty coverage. Damage caused by
the use of third-party supplies or parts may not be covered by the warranty.
To accept any and all of these risks, and to proceed with the use of non-genuine supplies or parts in your printer, touch
and hold
and the # on the scanner control panel simultaneously for 15 seconds to clear the message and continue
printing.
If you do not want to accept these risks, then remove the third-party supply or part from your printer, and then install
a genuine Lexmark supply or part.
Note: For the list of supported supplies, see the "Ordering supplies" section of the User's Guide or visit
www.lexmark.com.
Not enough free space in flash memory for resources [52]
Try one or more of the following:
•
From the scanner control panel, touch Continue to clear the message and continue printing.
•
Delete fonts, macros, and other data stored in the flash memory.
•
Install a flash memory card with larger capacity.
Note: Downloaded fonts and macros not previously stored in the flash memory are deleted.
Paper changes needed
Try one or more of the following:
•
Touch Use current supplies to clear the message and continue printing.
•
Cancel the current print job.
Parallel port [x] disabled [56]
Try one or more of the following:
•
From the scanner control panel, touch Continue to clear the message.
•
Enable the parallel port. From the scanner control panel, navigate to:
Network/Ports > Parallel [x] > Parallel Buffer > Auto
304
Advertisement
Table of Contents
