Installing The Hard Drive Tray - Dell PowerEdge R730xd Owner's Manual

Figure 23. Removing the hard drive tray
1. hard drive tray handle (2)
3. hard drive indicator
5. backplane signal cable
7. guide pin on the chassis (4)
Next steps
1. Install the hard drive tray. See the Installing the hard drive tray section.
2. Follow the procedure listed in the After working inside your system section.
Related Links
Safety instructions
Before working inside your system

Installing the hard drive tray

After working inside your system
Installing the hard drive tray
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
NOTE: Systems that support the internal hard drive tray support low-profile heat sinks and do not
support a cooling shroud.
Steps
1. Lift the hard drive tray handles to the 90-degree angle position.
2. Hold the hard drive tray handles and align the slots on the hard drive tray with the guide pins on the
chassis.
3. Slide the hard drive tray into the chassis.
4. Lower the hard drive tray handles to lock the hard drive tray in place.
2. hard drive (4)
4. SAS cable
6. backplane power cable
85