Initializing The Tpm For Bitlocker Users; Initializing The Tpm For Txt Users; Hard Drives - Dell PowerEdge R730xd Owner's Manual

Installing the system board
After working inside your system

Initializing the TPM for BitLocker users

Initialize the TPM.
For more information about initializing the TPM, see
cc753140.aspx.
The TPM Status changes to Enabled, Activated.

Initializing the TPM for TXT users

1. While booting your system, press F2 to enter System Setup.
2. On the System Setup Main Menu screen, click System BIOS → System Security Settings.
3. From the TPM Security option, select On with Pre-boot Measurements.
4. From the TPM Command option, select Activate.
5. Save the settings.
6. Restart your system.
7. Enter System Setup again.
8. On the System Setup Main Menu screen, click System BIOS → System Security Settings.
9. From the Intel TXT option, select On.

Hard drives

Your system supports entry hard drives and enterprise-class hard drives. Entry hard drives are designed
for 5x8 operating environment with less workload rating to drives and enterprise-class drives are
designed for 24x7 operating environment. Selecting the correct drive class will enable the critical areas of
quality, functionality, performance, and reliability to be optimized for the target implementation.
NOTE: Do not mix enterprise-class hard drives with entry hard drives.
Choosing the right drive type depends on the usage pattern. Improper use of entry hard drives (workload
rating exceeds 55TB/year) will lead to significant risk and increase the drives failure rate.
For more information on these hard drives, see the 512e and 4Kn Disk Formats whitepaper and 4K Sector
HDD FAQ document at Dell.com/poweredgemanuals.
All hard drives are connected to the system board through the hard drive backplane. Hard drives are
supplied in hot-swappable hard drive carriers that fit in the hard drive slots.
CAUTION: Before attempting to remove or install a hard drive while the system is running, see the
documentation for the storage controller card to ensure that the host adapter is configured
correctly to support hot-swap hard drive removal and insertion.
CAUTION: Do not turn off or restart your system while the hard drive is being formatted. Doing so
can cause a hard drive failure.
Use only hard drives that have been tested and approved for use with the hard drive backplane.
176
http://technet.microsoft.com/en-us/library/