Installing The Hard Drive Tray - Dell EMC PowerEdge R730xd Owner's Manual

Next steps
1. Install the hard drive tray. See the Installing the hard drive tray section.
2. Follow the procedure listed in the After working inside your system section.
Related references
Safety instructions on page 67
Related tasks
Before working inside your system

Installing the hard drive tray

After working inside your system
Installing the hard drive tray
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
Systems that support the internal hard drive tray support low-profile heat sinks and do not support a cooling
NOTE:
shroud.
Steps
1. Lift the hard drive tray handles to the 90-degree angle position.
2. Hold the hard drive tray handles and align the slots on the hard drive tray with the guide pins on the chassis.
3. Slide the hard drive tray into the chassis.
4. Lower the hard drive tray handles to lock the hard drive tray in place.
5. Connect the SAS, power, and signal cables to the backplane.
Figure 24. Installing the hard drive tray
1. hard drive tray handle (2)
3. hard drive indicator
5. backplane signal cable
7. guide pin on the chassis (4)
Next steps
Follow the procedure listed in the After working inside your system section.
78 Installing and removing system components
on page 68
on page 78
on page 68
2. hard drive (4)
4. SAS cable
6. backplane power cable