Installing The Hard Drive Backplane In The Hard Drive Tray - Dell PowerEdge R730xd Owner's Manual

Steps
Press the release tabs and lift the backplane out of the hard drive tray.
Figure 31. Removing the 3.5 inch (x4) hard drive backplane
1. release tab (2)
3. hard drive connector (4)
5. hard drive backplane
Related Links
Safety instructions
Before working inside your system
Removing a hard drive carrier from the hard drive tray
Removing the hard drive tray

Installing the hard drive backplane in the hard drive tray

Prerequisites
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
Steps
Align the hard drive backplane with the guide pin on the chassis and lower the hard drive backplane
on the chassis until it is firmly seated.
Next steps
1. Install the hard drives carriers into the hard drive tray.
2. Install the hard drive tray into the chassis.
94
2. hard drive indicators
4. guide pin