The Function Menu - Avaya 3616 Installation And Configuration Manual

E.g. If line 1 is assigned to Programmable Key 1,
to Programmable Key 4,
Changes to feature programming will take effect when the Wireless
Telephone is powered off and back on again.
If an Open Application Interface (OAI) is operational, a function key
sequence will be assigned in the OAI configuration and will override any
function sequence established here.
8.2

The Function Menu

The off-hook Function Menu displays the features on the Wireless Telephone that have been
programmed into the Call Server for use by the Wireless Telephone.
Display the Function Menu on the 3616/3626 Wireless Telephone by pressing
and then press . The display will show the first two features:
FCN
1= Mute
2= LND
Press repetitively to step through the Function Menu. Each display shows two features, the first
FCN
three displays show the five assigned features as above.
The displays for the remaining function key sequences show the features that have been programmed
in the Call Server with whatever abbreviations the program uses for those features. These features
automatically appear on the Wireless Telephone display when the programming is done and the
Wireless Telephone is powered off and back on, there is no separate programming action to set this up.
The Function Menu will show an asterisk in front of any active feature – that is, any feature that is
currently activated. If a feature is not activated, there will be a blank space in front of the active feature
abbreviation.
For example: If
FCN+6
activated, the display will show
display .
6= SAC
The presence of the asterisk depends on the communication between the Call Server and the Wireless
Telephone. If the Call Server does not send an active message to the Wireless Telephone, that
particular feature will not display an asterisk when active.
For features that are activated by the Wireless Telephone, such as SAC, the corresponding function
key may be pressed at any time in order to activate or deactivate the feature.
For example: Press
Power On / Start Call
SAC. The display will then show
555-301-107, Issue 1
July 2003
+ will access line 2.
LINE 2
is programmed to the Send All Calls feature (SAC), when the SAC feature is
. When the feature is not active, the Function Menu will
6= * SAC
,
FCN
.
6= SAC
3616/3626 Wireless IP Telephone
Installation and Configuration Guide
+ will access line 1. If line 2 is then assigned
LINE 1
, , to display
FCN FCN
Power On / Start Call
. Press to deactivate
6= * SAC 6
29