Installing The Hood Latch (Ce Only) - Toro 03170 Operator's Manual

5
Installing the Hood Latch (CE
Only)
Parts needed for this procedure:
1 Lock bracket
2 Rivet
1 Washer
1 Screw, 1/4 x 2 inches
1
Locknut, 1/4 inch
Procedure
1. Unhook the hood latch from the hood latch bracket.
2. Remove the (2) rivets securing the hood latch bracket
to the hood (Figure 7). Remove the hood latch
bracket from the hood.
2
1. Hood latch bracket
3. While aligning the mounting holes, position the CE
lock bracket and the hood latch bracket onto the
hood. The lock bracket must be against the hood
(Figure 8). Do not remove bolt and nut assembly
from the lock bracket arm.
1
G012628
Figure 7
2. Rivets
1. CE lock bracket
4. Align the washers with the holes on the inside of the
hood.
5. Rivet the brackets and the washers to the hood
(Figure 8).
6. Hook the latch onto the hood latch bracket
(Figure 9).
1
1. Hood latch
7. Screw the bolt into the other arm of hood lock
bracket to lock the latch in position (Figure 10).
Tighten bolt securely but do not tighten nut.
3
2
1. Bolt
2. Nut
17
1
2
G012629
Figure 8
2. Bolt and nut assembly
G012630
Figure 9
1
G012631
Figure 10
3. Arm of hood lock bracket