Mounting The Cutting Units - Toro 03170 Operator's Manual

1. Rear carrier frame
2. Front mounting link
10

Mounting the Cutting Units

No Parts Required
Procedure
1. Slide a thrust washer onto each front lift arm pivot
rod.
2. Slide the cutting unit carrier frame onto the pivot rod
and secure it with a lynch pin (Figure 20).
Note: On rear cutting unit, position the thrust
washer between the rear of the carrier frame and
the lynch pin.
1. Thrust washer
2. Carrier frame
Figure 19
3. Rear mounting link
Figure 20
3. Lynch pin
3. Grease all the lift arm and carrier frame pivot points.
Important: Ensure that the hoses are free of
twists or sharp bends and that the rear cutting
unit hoses are routed as show in (Figure 21).
Raise the cutting units and shift them to the left
(Model 03170). The rear cutting unit hoses must
not contact traction cable bracket. Reposition
the fittings and/or hoses, if necessary.
4. Route a tipper chain up through the slot on the end
of each carrier frame. Secure the tipper chain to the
top of the carrier frame with a bolt, a washer, and a
locknut (Figure 22).
1. Tipper chain
21
Figure 21
Figure 22