Replacing Pivot Shaft - Serial 312000001 & Up, Serial 313000001 & Up - Toro 23515 Service Manual

6. Slide the oval locking rings upward on the handle
and fold the handle towards the engine.
7. The ball joint on the tine-control lever should contact
the handle firmly (Fig. 059); if not, proceed to step 8.
B C
A
C
B
A
Fig. 059
A. Handle
B. Self-propel drive bail
C. Tine control lever
8. Loosen both jam nuts, on both ends of the link rod,
next to the ball joints (Fig. 059).
9. Turn the link rod, by hand, until the ball joint on the
tine-control lever is tight against the handle (Fig.
059).
10. Tighten both jam nuts on the link rod next to the ball
joints.
Toro 21" Aerator Service Manual
D E
F
fig. 20 G023658
D. Jam nut
E. Link rod
F. Ball joint contacts
handle
Replacing Pivot Shaft - Serial
312000001 & up, Serial 313000001 &
up
1. Lower the tines to the ground to take pressure of the
lift system.
2. Remove the tine control cable from the tine control
bracket (Fig. 060).
Fig. 060
3. Remove the snap ring and washers from the wheel
arm (Fig. 061).
Fig. 061
CHASSIS
3
lift lower cable 2
snap ring & washers_a
3-13