Adjusting The Self-Propel Drive 2014 Models (Serial 314000001 & Up) - Toro 23515 Service Manual

4. Adjust the reverse speed stop as follows:
• Loosen the 2 nuts on the reverse speed stop (Fig.
034).
• Move the stop down to the midpoint or slightly
past it and tighten the 2 nuts (Fig. 034).
Note: The reverse speed should be around 2.0 MPH
(3.2km/h).
A
Fig. 034
A. Nuts
Toro 21" Aerator Service Manual
SPECIFICATIONS & MAINTENANCE
Adjusting the Self-Propel Drive 2014
models (Serial 314000001 & up)
1. Raise the tines, stop the machine, stop the engine,
and disconnect the spark plug wire.
2. Squeeze the self-propel bail to the handle until the
transmission is fully stroked. If the bail contacts the
handle, release the bail. Loosen the top adjustment
nut one turn and tighten the bottom adjustment nut.
Squeeze the bail to the handle. Repeat this step until
there is a gap (up to 1/8" (3mm)) between the self-
propel bail and the handle (Fig. 035).
A
fig. 32 G020486
A. Self-propel drive bail
B. Cable
B
C
Fig. 035 fig. 34 G023021
C. Top/Bottom adjustment
nuts
2
2-21