Drive Cable Removal & Installation - Toro 23515 Service Manual

Drive Cable Removal & Installation
1. Remove the cotter key and pin from the drive
handle. Loosen the lock nuts on the handle and
remove cable (Fig. 043).
Fig. 043
2. From under the machine, loosen the cable lock nuts
and remove the linkage that connects the cable to
the transmission. Remove the cable (Fig. 044).
Fig. 044
Toro 21" Aerator Service Manual
3. Install new cable. Install the linkage to the trans-
mission and install all of the lock nuts and tighten.
Adjust the cable as follows:
4. Adjust the traction drive cable at the lower anchor
by moving the nut to the end of the thread and
tightening the jam nut (Fig. 045).
drive cable 1
A. Nut
drive cable 2
CHASSIS
A B
Fig. 045 fig. 30 G020484
B. Jam nut
3
3-7