Toro 23515 Service Manual page 14

SPECIFICATIONS & MAINTENANCE
5. The lower ball joint bolt, on the upper link rod, should
be offset 1/4" (6mm) from the handle pivot bolt. If
not, loosen the lock nuts on the lift link strap ball
joints, adjust as necessary, and retighten locknuts
(Fig. 006).
2
A. Handle pivot bolt
B. Lower ball joint bolt
C. 1/4" (6mm)
2-6
B
A
C
E
Fig. 006 fig. 19 G023657
D. Lift link strap ball joint
E. Adjust here
6. Slide the oval locking rings upward on the handle
and fold the handle towards the engine.
7. The ball joint on the tine-control lever should contact
the handle firmly (Fig. 007); if not, proceed to step 8.
B C
D
A
B
A. Handle
B. Self-propel drive bail
C. Tine-control lever
8. Loosen both jam nuts, on both ends of the link rod,
next to the ball joints.
9. Turn the link rod, by hand, until the ball joint on the
tine-control lever is tight against the handle.
10. Tighten both jam nuts on the link rod next to the ball
joints.
DE
F
C
A
Fig. 007
D. Jam nut
E. Link rod
F. Ball joint contacts here
Toro 21" Aerator Service Manual
fig. 20 G023658