Photo - Yamaha CRX-E500 Service Manual

CDC-E500
7. Installation of Drawer
a. While holding the drawer in the normal operating, align
the lug located on the left side of the drawer to the
position where the collar of the arm stopper B is and
push it into the chassis. (Photo 27)
b. With the right side of the drawer loose, fit the claw on
the left side of the chassis (at the rear) into the groove
in the drawer. A light push on the drawer will facilitate
fitting. (Photo 28)
c. Lift the right side of the drawer, and the claw at the front
fits in the groove as well.
d. When the drawer is installed properly, the rack of the
drawer should mesh with the gear idler A on the slider
2.
e. In this state, lower the right side of the drawer to the
horizontal level and move forward and rearward by
about 5mm to check that there is some resistance.
If it moves lightly, move back to Step "a" above to
ensure the gear meshed securely.
The same is applicable when the arm has lifted. Check
that the arm stopper B and slider 2 are meshed and
then reinstall the drawer.
f. Check to make sure that the bevel gear is positioned
properly on the chassis and latch the claw on the right
side.
g. Adjust the bevel gear position so that the grooves in the
right side of the drawer and in the bevel gear match and
make the groove in the right side of the drawer mesh
with the chassis claw. (Photos 29 and 30)
18
Drawer lug
Collar of arm stopper B

Photo 27

Chassis claws
Photo 28
Groove in bevel gear 1
Photo 29
Make chassis claws mesh with the groove in the drawer.
Photo 30
Groove in drawer