Switches 4 And - Yamaha CRX-E500 Service Manual

h. While pushing down the point shown in photo 17 with a
small tool, like tweezers, move the PC board B to the
right to remove it. (Photo 17)
i. Unsolder the PC board B and replace the switches.
j. Reversing the above procedure starting from Step "i",
install the PC board B to the chassis and restore the
mechanism in the original state.
k. After installing the lifter, check to ensure that the lifter
moves up and down without resistance when it is
pushed down.
Precaution required when installing the spring to the
lifter:
Fit the end of the spring into a pocket in the lifter at the
front and install it to the chassis. (Photo 19)
PC board B (with switches 4 and 5 installed)
While pushing this part, turn the PC board
in the arrow direction to remove it.
Photo 17
Member fixing the PC board B
Photo 18
(Chassis viewed from the back)
Pocket to fit in the end of spring
Photo 19
CDC-E500
No pocket on this side
15