Photo - Yamaha CRX-E500 Service Manual

d. Install the left side of the carriage under the collar of the
star gear, and then the right side by pushing it with your
fingers. (Photo 23)
e. Turn the bevel gear toward the rear (clockwise) so that
the carriage moves completely forward. (The pinion
makes about 5 full turns during this process.)
f. Keep turning the bevel gear in the same direction, and
the lower pinion starts to turn.
When the lower pinion stops turning, stop turning the
bevel gear. (Photo 25)
g. Install another carriage in the same manner.
h. Before turning the bevel gear, push up the carriage that
has already moved slightly with hand. (Photo 24)
i. Turn the bevel gear toward the rear again. The carriage
that has moved forward is raised by the start gear first.
j. Continue turning the bevel gear, and the carriage
remaining at the rear moves forward.
k. In this state, set the drawer back in the original state.
l. Move the cam gear so that the cut line in it is positioned
as Photo 26 shows.
Push in the carriage Carriage
with fingers.
Drawer

Photo 23

Front
Push up here with a finger before
moving the next carriage.
Photo 24
Turn the bevel gear continuously after moving the
carriage that has been installed first, and the lower pinion
starts to turn.
Photo 25
(Enlarged view of section A)
Line on Cam RR3 or RF2
Photo 26
CDC-E500
Bevel gear turning direction
Section A
Lower pinion
Lines of cam RR3 and
cam RF2 should be
within this range.
17