Yamaha CRX-E500 Service Manual page 10

CDC-E500
2. Opening of Drawer
a. Move the lever under the left side face of the
mechanism toward the front side first and then toward
the rear side.
The drawer is unlocked and opens by about 5 to 10cm.
(Photo 2)
b. Pull out the drawer to open it fully. (Photo 3)
3. Removal of Drawer
a. Open the drawer as described in Procedure 2 above.
The drawer can be removed without being opened but
its removal would be easier if it is open because there
would be one less claw locking the drawer.
b. While holding the rear of the drawer by one hand, push
each claw section outward and remove the drawer.
Also, the drawer can be removed by lifting it up while
pushing it inward of the mechanism.
As there are two claws each on the right and left, repeat
the above procedure on both sides. (Photos 4 and 5)
c. Turn over the removed drawer and place it on the right
side of the chassis. (As the drawer is connected to the
chassis with a lead wire, it cannot be separated
completely.)
Claws on the right side
10
Photo 5
1
Rear
lever 2
Photo 2
Photo 3
(Drawer opened fully)
Claws on the left side
Photo 4
Front