Photo - Yamaha CRX-E500 Service Manual

CDC-E500
6. Installation of Carriages
a. Check that the bevel gear is installed to the drawer. If it
is not, install it according to Step b of Procedure 4.
b. Turn the bevel gear toward the rear (clockwise) until the
upper pinion starts to turn. (Photo 20)
c. Install the carriage (starting with the largest No. one
first) so that the first tooth fits between the pins of the
upper pinion. (Photos 21 and 22)
16
Cam RR3 (black)
Drawer opening
direction
Both marks on upper and lower pinions
should be on the cam RR3 side.
Carriage No. 3 Carriage No. 2
(with 2 lugs) (with a lug at
the front)

Photo 22

Bevel gear turning direction
Upper pinion
Photo 20
Carriage No. 1
(with a lug at
the rear)
Photo 21