D-Link DGS-3427 User Manual page 103

The user-changeable parameters are as follows:
Parameter
Group ID
State
Master Port
Member Ports
Flooding Port
Active Port
Type
After setting the previous parameters, click Apply to allow your changes to be implemented. Successfully created trunk
groups will be show in the Current Link Aggregation Group Entries.
xStack DGS-3400 Series Fast Ethernet Switch
Figure 7- 11. Link Aggregation Settings window - Modify
Description
Select an ID number for the group, between 1 and 32.
Trunk groups can be toggled between Enabled and Disabled. This is used to
turn a port trunking group on or off. This is useful for diagnostics, to quickly
isolate a bandwidth intensive network device or to have an absolute backup
aggregation group that is not under automatic control.
Choose the Master Port for the trunk group using the pull-down menu.
Choose the members of a trunked group. Up to eight ports per group can be
assigned to a group.
A trunking group must designate one port to allow transmission of broadcasts
and unknown unicasts.
Shows the port that is currently forwarding packets.
This pull-down menu allows you to select between Static and LACP (Link
Aggregation Control Protocol). LACP allows for the automatic detection of
links in a Port Trunking Group.
92