York Fitness G510 Instruction Manual page 13

INSTRUCTION
Locate the LAT PULL CABLE (88) with threaded bolt
and route as shown. Fix a SNAP LOCK HOOK (60)
to the end with the ball stop.
(NOTE: Fix the pulley assemblies in place once cable is
routed - this may save them having to be removed
and re-located.)
Locate and fit all PULLEY WHEEL (83) + PULLEY
WHEEL COVER ASSEMBLIES (84) as shown using fixings
(Nuts / Bolts / Washers etc) as detailed.
When fitted correctly pulley covers will protect you from potential
squeeze points ensure that the cable enters and exits from the pulley
through the channels provided in the pulley covers.
Ensure PULLEY WHEEL SPACERS (54) are fitted where illustrated.
Locate 1 x ADJUSTABLE PULLEY BRACKET (23) and
the fixings to assemble the central pulley assembly.
32
M10 x 65mm HEX HEAD BOLT x
SHOULD YOU REQUIRE ANY ASSISTANCE REGARDING THIS PRODUCT PLEASE CONTACT YORK DIRECTLY
11
2
Pulley cover wrong
Not inside
slot
Ensure that the cables are located in the grooves where they
enter and exit the pulley.
54
34
M10 x 50mm HEX HEAD BOLT x
SPACER
ADJUSTABLE
PULLEY BRACKET
THREAD THIS
END FIRST
Pulley cover right
Exit
point
48
11.5mm LONG
4
SPACER x
M10 NYLON
LOCKNUT x
49
M10 x 23mm x 2mm
12
FLAT WASHER x
YORK G510 / 11
Entry
point
6
4