Sharp AR-C260P Operation Manual page 64

SADDLE STITCH FINISHER
11 Raise the lever at the end of the staple box.
Return the lever to its original position.
12
Reinstall the staple box.
13
I I I I Disposal of hole punch scrap (when the punch unit is installed)
1 Unlatch the saddle stitch finisher and slide
it away from the main unit.
2 Pull out the punch scrap container and
empty it.
5-6
Remove the top staple if
it is bent. If bent staples
remain, a staple jam will
occur again.
Push the staple box in
until it clicks into place.
Discard the punch
scraps in a plastic bag or
other container, taking
care not to let the scraps
scatter.
14 Push the stapler section back into the
finisher.
Close the front cover.
15
16 Push the saddle stitch finisher back
against the main unit.
NOTE
Make a test print in the staple sort mode to ensure
that stapling is performed properly.
3 Return the punch scrap container to its
original position.
4 Push the saddle stitch finisher back
against the main unit.