Custom Settings; G Basic Procedure For Custom Settings; Basic Procedure For Custom Settings - Sharp AR-C260P Operation Manual

CUSTOM SETTINGS

The custom settings allow you to set the following parameters.
G Tray settings ................................ Paper type and paper size* settings for each tray (see pages 2-11 and
*The paper size setting is only used when a tray's paper size slide is set to "EXTRA". Be sure to set the paper type.
G Auto tray switching....................... This setting enables automatic switching between trays loaded with the
G Print list ........................................ Used to print a list of machine settings. (See page 2-19)
G Total count ................................... The number of pages printed by the machine and optional equipment can
G Clock .............................................. Used to set the date and time of the printer's built-in clock. (See page 2-19)

Basic procedure for custom settings

1 Press the [MENU] key repeatedly until
"CUSTOM SETTINGS" appears.
2 Press the [OK] key.
Press the or
3
setting.
4 Press the [OK] key.
2-14).
same type and size of paper. If one tray runs out of paper during printing,
printing will continue from the other tray. (See page 2-19)
be displayed. (See page 2-19.)
Any print jobs held in the
printer and any jobs
currently being
transmitted to the printer
will be printed using the
previous custom
settings.
key to select the desired
5 Press the or
selection for the setting appears.
For information on the selections for each setting,
see the explanations on page 2-19 and following.
Press the [OK] key.
6
In this case, press the
selection for the parameter appears and then
press the [OK] key to store it. To configure another
custom setting, press the [BACK/C] key and
repeat steps 5 and 6.
When you have finished configuring the
7
settings, press the [MENU] key to return to
the initial screen.
NOTE
The [BACK/C] key can be used to move back to the
previous setting level. This is useful if you
accidentally select the wrong setting.
key until the desired
" " will appear to the
right of the selection and
the selection will be
stored. Some settings
may require the
configuration of
additional parameters.
or until the desired
2-17
2