Sharp AR-C260P Operation Manual page 48

TROUBLESHOOTING
Problem
Smudges on printed Does a message appear indicating the
sheets need for maintenance?
Colour deviations When printing in colour, text and colour
occur. deviations appear.
The displayed paper
The tray's paper size slide is not set to
size differs from the
the correct size for the paper in the tray.
loaded paper size.
When printing on an
The paper size slide in the tray is set to
"extra" size of
"extra", however, the correct paper size
paper, part of the
is not specified in the paper tray settings
printed image is
of the custom settings.
missing.
When printing on a
non-standard size
of paper using the The paper size setting for the bypass
bypass tray, part of tray is not correct.
the printed image is
missing.
Is
SHARP-recommended
used?
Paper curled or damp?
Is the paper curled and does it
frequently
Paper misfeeds
module/2 x 500 sheet paper drawer or
frequently.
saddle stitch finisher?
Multiple
simultaneously?
Is
SHARP-recommended
used?
Is paper size or weight outside of the
permitted range?
Printed paper is
Do wrinkles appear when printing
wrinkled or the
envelopes?
image rubs off
easily.
Is the pressure adjustment lever of the
fusing unit out of position?
Paper damp?
2-30
Check
paper other
paper being
misfeed in the duplex
sheets of paper
paper other
paper being
Solution or cause
Please contact your dealer as soon as possible.
Perform colour registration as explained on
pages 9 and 10 of the key operator's guide.
When you change the paper size in the tray, be
sure to adjust the paper size slide on the tray to
the new paper size. (page 2-3)
Specify the correct paper size in the paper tray
settings of the custom settings (see pages 2-12
to 2-13). If the paper size setting is not correct,
part or all of the image may not print (this
depends on the options installed).
Set the correct paper size as explained on pages
2-14 to 2-16. If the paper size setting is not
correct, part or all of the image may not print (this
depends on the options installed).
than
Use SHARP-recommended paper. (pages 2-10
and 2-22)
Do not use curled or crimped paper. If you are
not going to use paper for a long time, store the
paper in the wrapper in a dry location.
Some types of paper may curl inside the
machine. Turning the paper over in the tray may
help reduce misfeeding due to curling.
fed
than
Use SHARP-recommended paper. (pages 2-10
and 2-22)
Use paper in the permitted range.
Moving the pressure adjusting levers of the
fusing unit from the normal position to a weaker
pressure position may help alleviate this
problem. (page 2-6)
Return the pressure adjusting levers of the
fusing unit to the normal position. (page 2-7)
Be sure to store paper in the wrapper in a dry
location. Do not store paper in a location that is:
Ghumid
Gextremely hot or cold.
Remove the paper
from the paper tray
or the bypass tray,
fan the paper as
shown in the
illustration, and
then load it again.