Hold Job List - Sharp AR-C260P Operation Manual

HOLD JOB LIST

When sending a print job to the machine from your computer, you can select the "Hold After Print", "Hold Before Print"
or "Proof Print" option. When one of these options is selected, the machine will hold the print job. To print or delete
a hold job, use the operation panel of the machine as explained below. A maximum of 100 jobs can be held. Print
jobs held by this function will not be erased even if the main switch is turned off.
If the number of jobs exceeds 100, the job is processed as follows:
G If Hold After Print is executed:
Printing will be executed but the job will not be held. (A notice page will be printed. See page 4-6 of the Operation
manual (for printer).)
G If Hold Before Print is executed:
Printing will not be executed and the job will not be held. (A notice page will be printed. See page 4-6 of the
Operation manual (for printer).)
G If Proof Print is executed:
Printing of one set will be executed but the job will not be held. (A notice page will be printed. See page 4-6 of the
Operation manual (for printer).)
If one of the above situations occurs and the Printer Status Monitor has been installed, an error message will appear
on the PC monitor.
Press the [MENU] key.
1
2 Press the [OK] key.
ARAI
WORD-1
3 Select the desired job.
4 Press the [OK] key.
4-2
"PRINT JOBS ON
HOLD" will appear in the
message display.
The user name and
application name of the
first hold job will appear.
Press the or key
on the operation panel
repeatedly until the
desired print job is
displayed.
If a PIN number must be entered, press the
5
or key repeatedly until the first digit
of the PIN appears, and then press the
[OK] key.
Be sure to enter the same PIN number that was
entered on the computer. If a PIN number was not
set, skip steps 5 and 6 and go directly to step 7.
PIN
----
" " will appear and "-" in the second digit will
blink. If you need to correct the previous digit,
press the [BACK/C] key to move back.
NOTE:
The password is entered one digit at a time. Digits not
yet entered are shown as "-".
6 Repeat step 5 to enter the second through
the fifth digits of the PIN number.
PIN
----
When you press the
[OK] key to store the first
digit after entering it,