Misfeed Removal - Sharp AR-C260P Operation Manual

MISFEED REMOVAL

When a misfeed has occurred, printing will stop and the message shown below will appear. Follow the procedure
below to remove misfed paper.
PAPER JAM.
[i]
General misfeed removal procedure
When a misfeed occurs, follow these steps to check the number that indicates the general location of the misfeed.
The numbers and their corresponding locations are shown in the table below. The numbers and locations are also
shown in the illustration on the inside of the front cover.
Press the INFORMATION key.
1
Press the key twice.
2
Display example
1 2 3 4 5 6 7 8
9 10 11 12 13
NOTES
G Be careful not to tear
the misfed paper
during removal.
G If paper is accidentally
torn during removal,
be sure to remove all
pieces.
G Take
care not to
damage or leave
fingerprints on the
transfer belt when
removing the misfed
paper.
Use the or keys to
scroll through the guidance
messages.
For the location that the
number indicates, see
the illustration on the
inside of the front cover.
CAUTION
The fusing unit is hot. Take care in removing paper.
Upper fusing unit
The procedures for removing misfeeds from each
location are explained on the pages indicated
below.
Number Location
1, 2 For misfeeds in large capacity tray
• Misfeed in the transport area
• Misfeed in the 500 sheet paper
drawer
3, 5
• Misfeed in the stand/1 x 500 sheet
paper drawer or the stand/3 x 500
sheet paper drawer
4 Misfeed in the bypass tray
Misfeed in the fusing area, and exit
6, 7, 8
area
9 Misfeed in the saddle stitch finisher
10, 11, Misfeed in
12 bypass/inverter unit
Misfeed in the duplex module/2 x
13
500 sheet paper drawer
3 Press the INFORMATION key to close the
misfeed removal guidance.
Fusing unit paper guide
Page
5-11
2-25
2-24
2-26
2-24
2-25
5-7
the duplex
2-27
2-27
Transfer belt
2-23
2